How to identify ford 427. The 427 is real expensive, but puts out the most HP.

How to identify ford 427 The 406 also had cross-bolted mains, but didn't have the screw-in brass plugs, unless further maching was done to install them after the fact. Because Ford has long been infamous for engineering changes, you can count on a plethora of block castings in a single model year. It will not have any performance features other than: 1) If it's a 1964 block it'll have the undrilled crossbolt nubs. There’s been some discussion on another forum that what should be a 3 in the casting number looks like an 8. It looks like a 385 series which means it may be either a 429 or a 460. Many 427s can be identified by the combination of the 6 screw-in brass plugs on the engine block sides and just below them is the crossbolts for the mains. I am leaning toward a 429. The 352/390/410/427/428 all make up the "FE" (Ford/Edsel) engine family. You can be assured the person selling the 2-bolt 427 block is actually selling a 352 or 360/390 block with phantom 427 features, not a real 427. So how do you tell if it is a side or top oiler from here??. This is a new old stock 427 side-oiler. Last edited by Madathlon; 09-01-2009 at 08:03 PM. Whether you’re building a mild 332 for a vintage Ford restoration or erecting a stump puller of a 460, it’s important to know the difference between a good block and a bad one. This is for the 4 bolt main, and only a 427 has them. Of course it will have the hump on the side of the block, along with the pipe fittings on the side. No way to tell if it is actually the original. There is also the 3 small plugs with the hex heads screwed into the side of the block at the bottom of the oil galleys. And it comes in 3 versions, low rise, mediun riser, high riser. It appears to have a steel crankshaft rather than a cast one and also looks like it was balanced. One way to know if its a 427, is on the lower part of the block, should be 3 bolt head, Per side, that are along the lower edge, Simply take a pics of it and post, if there the right one, you have a 427. The blocks are interchangeable. Oh and the Single overhead cammer. So how do you tell if it is a side or top oiler from here?? Many 427s can be identified by the combination of the 6 screw-in brass plugs on the engine block sides and just below them is the crossbolts for the mains. The engines we'd like Appears to be the correct 427 block with the HP casting. In our discussion we'd like to examine the various visual cues that you can use to indentify the different classic Ford V-8 engines from the Ford Total Performance years. The 427 is real expensive, but puts out the most HP. I have the plug and the three plugs and hump along the left side so I After doing a little research and looking at pics I have confirmed that these blocks both have the side oil galleys on the left hand side of the block. Reason: added info. Look for a number on the crankshaft. Here's the easiest way to tell if it's a side oiler The arrow is pointing at a pipe plug. ztdw jqnj tbfoqbgn tsai urwjpt ejtqgh meotguq vsutmu eowiiafl ckzr